Phoenix Systems LLC
Office (703) 443-2699
Fax     (703) 738-7424
Class "A" Contractor
Builders License
Virginia License # 2705-0959-61 Expires 06-30-07


The Following Describes The Sequence Of Installing Your New Precision Entry Doors.

You will receive a call from the front office to set an appointment to do an exact measurement
on your door order.

We will order your doors.  When we receive them in our warehouse, we will call to set an
appointment for the installation.

For the most part, we normally install 1 or 2 doors per 2 person crew, per day.  For Pella wood
doors that lessens to 1 per day.

We ask that you remove your curtains or drapes and back the furniture from the doors.

If you have any valuables hanging on your walls, please take care to remove them as they
may become unstable in the construction process.

We will remove the doors starting with the storm door and work our way toward the inside.

We remove the whole door and frame down to the original wood jamb, inspect for rotted
wood on the floor and replace at no charge.  If there is rot on the floor joists it will be on a time
and material basis.

The frames of the doors are insulated with a collapsible foam insulation.

The door is then carefully installed and shimmed so as to be plumb and level.

The exterior wood brick molds are caped to the dimension of the brick mold or door trim with
a vinyl coated aluminum coil stock, custom bent and molded to your door on the job site.

Your interior trim will be replaced.

Next, we caulk and seal the exterior and interior of the door to keep out air and water.

Finally, we will vacuum the floor around the base of the door.

If you have a security system, we will remove the units, however we are not electricians and
ask you to please call them to reinstall the system.  (We don't want to cause a false alarm)